Christie Mirage WQ-L User Manual page 26

The length of the connections depends on ArrayLOC network switch placement within the
array. It may be possible to reuse the Ethernet cable supplied with the projector for one of
these connections, but at least one connection requires that you supply an additional
Ethernet cable per projector.
ArrayLOC over ArrayLOC Network (preferred)
The ArrayLOC Network should be used if you want to isolate the ArrayLoc network traffic from the
Control Network.
1. Connect a standard CAT5 Ethernet cable between the ArrayLOC network switch and the
ArayLOC Network port on the projectors input panel.
2. From the Main menu, select ArrayLOC > ArrayLOC Configuration.
3. From the ArrayLOC Network drop-down list select ArrayLOC Network.
The length of the connections depends on ArrayLOC network switch placement within the
array. It may be possible to reuse the Ethernet cable supplied with the projector for one of
these connections, but at least one connection requires that you supply an additional
Ethernet cable per projector.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
CAT5 CAT5
ArrayLOC
Network Switch
CAT5 CAT5
CAT5 CAT5 CAT5 CAT5
ArrayLOC
Network Switch
CAT5 CAT5 CAT5 CAT5
CAT5 CAT5
Installation
26