Christie Mirage WQ-L User Manual page 74

ABL
DEVC
WENA
WBTH
WGTH
IRTG
SKEY
SFRD
AFRD
AFRS
SRGB
SCLE
SITP
Examples:
(ABL+MODE1) Enable Array Bright/ColorLOC.
(ABL+MODE2) Disable Array Bright/ColorLOC.
(ABL+BRGP 2) Set the brightness group to 2.
(ABL+BRTG 400) Set the brightness target to 400 Lumens.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Specifies the ethernet port used for transfer of ColorLOC data.
When selected will use the Control Network port rather than
default ArrayLOC Network port.
0 = ArrayLOC network
1 = Control network
(FUTURE USE).
Enable warnings associated with Bright/ColorLOC.
0 = disable
1 = enable
(FUTURE USE). Sets the brightness threshold at which a
warning is issued when warnings are enabled. (0-100 percent).
(FUTURE USE). Sets the gamut threshold at which a warning is
issued when warnings are enabled (0-100 percent).
(FUTURE USE). IR Brightness Target. Sets the target brightness
that the projectors in the array brightness group should meet.
(Rang is 0-1000).
Synchronize remote control keystrokes, test pattern and color
enable amongst array projectors 
0 = Independent 
1 = Synchronized
Synchronize frame delay amongst array projectors 
0 = Independent 
1 = Synchronized
Sets the array frame delay parameter. Applies to all projectors
in array if SFRD is set to Synchronized
Read-only control reports smallest frame delay value in array
that will not generate tearing artifacts
Synchronize RGB Brightness setting amongst array projectors.
0 = Independent 
1 = Synchronized
Synchronize Color Enable setting amongst array projectors.
0 = Independent
1 = Synchronized
Synchronize Test Pattern setting amongst array projectors.
0 = Independent
1 = Synchronized
Serial Command Reference
74