Table of Contents
Advertisement
Add a GPIO Event
1. From the Advanced tab, click Add to open the RTE Wizard.
2. Select the GPIO Event tab.
3. For the GPIO Event option define the Input Condition field as required.
The Input Condition field contains seven blocks, which refer to the seven I/O pins on the
GPIO connector. Pin 1 = +12V and Pin 5 = Ground are not included or changed. Clicking a block
toggles between H, L and X.
See
Serial Communication
Add a Function Key Event
1. From the Advanced tab, click Add to open the RTE Wizard.
2. Select the Function Key Event tab.
3. Select a function from the drop-down list.
Advanced Tab—Serial
1. From the Advanced tab, select the secondary Serial tab.
2. Enter a serial command in the Serial Command field. See
3. Click Send to add the serial command.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
on page 63 for details.
Web UI Overview
Serial Communication
on page 63.
38
Advertisement
Table of Contents
