Table of Contents
Advertisement
Examples
Set 3D Emitter Delay to 20.00 milliseconds on main video.
TDD 2000
Returns the 3D Emitter Delay value on main video.
TDD?
3D SYNC INPUT (TDI)
The 3D sync signal is generated by the 3D source to ensure left/right eye content is synchronized to
the projector and to the user. The 3D Stereo cable has 2 inputs for right eye - left eye signals. This
control specifies which of the 2 right-left eye input signals on the cable is active.
It is important to ensure that the correct 3D sync input is selected (either Input A or Input B) with
each 3D signal source. If there is no external sync, then choose None and the sync will be
generated internally. This allows the content to be displayed, however, there is a 50% chance that
the content will be displayed with the left/right eyes swapped or inverted. This function is not used
in Interleaved 3D mode as each eye gets a dedicated input and no 3D sync input is required.
Parameters
•
Control Group: Preference
•
Subclass: Power Up
•
Access Level: Operator
Examples
Set 3D Sync Input to 'A' on main video.
TDI 0
Returns the 3D Sync Input value on main video.
TDI?
3D Mode (TDM)
Select the 3D mode:
• Off—3D operation is disabled.
• Dual Input 3D—Content from two independent 48-60Hz "passive" frame locked sources are interleaved into a
native 96-120Hz native frame rate. This requires an optional input module and both signals must be from the
same signal type.
Parameters
•
Control Group: Preference
•
Subclass: Power Up
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Serial Command Reference
102
Advertisement
Table of Contents
