Steering Cylinder - Kubota WSM STV32 Workshop Manual

STV32 · STV36 · STV40, WSM

(3) Steering Cylinder

Bi-speed Valve Assembly
1. The solenoid valve (4) (5) can be removed together with the
connector.
(1) Bi-speed Valve
(2) Filter
(3) Orifice Valve
(4) Solenoid Valve
(for Bi-speed Clutch)
Removing Steering Cylinder
See page 6-S5 to 6-S7.
Disassembling Steering Cylinder
1. Remove the rod joint (5) from the cylinder rod (4).
2. Draw out the cylinder cover (9).
3. Draw out the cylinder rod (4).
A Before insert the cylinder rod (4) with piston gasket (6),
through the piston gasket correcting tool (13) to prevent
damage the piston gasket.
A Apply clean transmission fluid to the piston gasket (6)
and bushing (7).
A Do not spin the cylinder rod (4) while inserting.
(When reassembling)
A Apply grease to the O-ring (8), rod gasket (10) and dust seal
(11).
A The plate (2) of cylinder tube (12) direction to front.
A Apply lock tight (Three Bod 1324 or equivalent) to the rod joint
(5).
A Be sure to check the toe-in after assembling. (See page 6-
S4.)
Tightening torque Rod joint screw
(1) Power Steering Cylinder
Assembly
(2) Plate
(3) Tie Rod
(4) Cylinder Rod
(5) Rod Joint
(6) Piston Gasket
8-S19
HYDRAULIC SYSTEM
(5) Solenoid Valve
(for PTO Clutch)
(6) Connector
(7) Joint
0000007861E
0000007862E
123.6 to 147.1
12.6 to 15.0
91.1 to 108.5 ft-lbs
(7) Bushing
(8) O-ring
(9) Cylinder Cover
(10) Rod Gasket
(11) Dust Seal
(12) Cylinder Tube
(13) Piston Gasket Correcting Tool
0000007863E
KiSC issued 04, 2006 A