Kubota WSM STV32 Workshop Manual page 96

STV32 · STV36 · STV40, WSM
Hydraulic Pipe and Fuel Pipe (Right Side)
1. Disconnect the fuel hose (3) from the fuel filter to drain fuel.
2. Disconnect the fuel return hoses from the fuel tank.
3. Remove the retaining screws (1) and separate the 3P
hydraulic delivery pipe (2) from the hydraulic pump.
4. Disconnect the bi-speed delivery pipe (6) from the hydraulic
pump.
5. Remove the retaining screw (4) of the oil cooler pipe and
loosen the clamp (5) of the joint hose.
Bi-speed delivery pipe
joint screw (Pump side)
Tightening torque
Bi-speed delivery pipe
retaining nut (Bi-speed
valve side)
(1) Retaining Screw
(2) 3P Hydraulic Delivery Pipe
(3) Fuel Hose
Propeller Shaft
1. Loosen the clamp screws (1) and slide the propeller shaft
cover (2).
2. Tap out the spring pin (3) and then slide the coupling (4).
3. Remove the propeller shaft with the cover.
(When reassembling)
A Apply grease to the spline portion of the propeller shaft and
couplings.
A When inserting the spring pins (3), face their splits in the
direction parallel to the propeller shaft.
A Tighten the clamp screws (1) upward from the bottom side.
(1) Clamp Screws
(2) Propeller Shaft Cover
1-S24
ENGINE
34.3 to 39.2
3.5 to 4.0
25.3 to 28.9 ft-lbs
29 to 49
3.0 to 5.0
21.7 to 36.2 ft-lbs
(4) Retaining Screw
(5) Clamp
(6) Bi-speed Delivery Pipe
0000007490E
(3) Spring Pin
(4) Coupling
0000007491E
KiSC issued 04, 2006 A