Kubota WSM STV32 Workshop Manual page 365

STV32 · STV36 · STV40, WSM
4) Light Switch Continuity when Setting Switch at LOW-
BEAM Position
1. Measure the resistance with an ohmmeter across the B1
terminal to the T terminal and the B1 terminal to the 2 terminal.
2. If 0 ohm is not indicated, the head light switch is faulty.
B1 terminal - T terminal
Resistance (Switch at
LOW-BEAM position)
B1 terminal - 2 terminal
5) Turn Signal Light Switch when Setting Switch Knob at
OFF Position
1. Set the turn signal light switch to the OFF position.
2. Measure the resistance with an ohmmeter across the B2
terminal to the R terminal and the B2 terminal to the L terminal.
3. If infinity is not indicated, the turn signal light switch is faulty.
B2 terminal - R terminal
Resistance (Switch at
OFF position)
B2 terminal - L terminal
6) Turn Signal Light Switch when Setting Switch Knob at
R Position
1. Set the turn signal light switch to the R position.
2. Measure the resistance with an ohmmeter across the B2
terminal to the R terminal.
3. If 0 ohm is not indicated, the turn signal light switch is faulty.
Resistance (Switch at R
B2 terminal - R terminal
position)
7) Turn Signal Light Switch when Setting Switch Knob at L
Position
1. Set the turn signal light switch to the L position.
2. Measure the resistance with an ohmmeter across the B2
terminal to the L terminal.
3. If 0 ohm is not indicated, the turn signal light switch is faulty.
Resistance (Switch at L
B2 terminal - L terminal
position)
9-S24
ELECTRICAL SYSTEM
0
0000001778E
Infinity
0000001779E
0
0000001780E
0
0000001781E
KiSC issued 04, 2006 A