Preparation; Separating Engine And Clutch Housing - Kubota WSM STV32 Workshop Manual

STV32 · STV36 · STV40, WSM

[2] PREPARATION

(1) Separating Engine and Clutch Housing

Draining Transmission Fluid
1. Place oil pan underneath the transmission case, and remove
the drain plugs (1).
2. Drain the transmission fluid.
3. Reinstall the drain plug (1).
(When reassembling)
A Fill new oil from filling port after removing the filling plug (2) up
to the upper notch on the dipstick (3).
A After running the engine for few minutes, stop it and check the
oil level again, if low, add oil prescribed level
A Use only KUBOTA SUPER UDT fluid. Use of other oils
may damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT" (See
page G-8.).
A Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed
for a few minutes to prevents damage to the transmission.
A Do not mix different blands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Oil Inlet
Hood, Side Cover and Battery Cord
1. Open the hood (1) and remove the front grille (3).
2. Disconnect the battery negative cable (2).
3. Disconnect the head light connectors and remove the side
covers (4) and hood (1).
(When reassembling)
A When disconnecting the battery cords, disconnect the
grounding cord first. When connecting, positive cord
first.
(1) Hood
(2) Battery Negative Cable
3-S17
TRANSMISSION
22 L
5.81 U.S.qts.
4.84 Imp.qts.
(3) Dipstick
0000007479E
(3) Front Grille
(4) Side Cover
0000007480E
KiSC issued 04, 2006 A