Kubota WSM STV32 Workshop Manual page 30

STV32 · STV36 · STV40, WSM
Replacing Hydraulic Oil Filter Cartridge
A Be sure to stop the engine before changing the oil filters.
A Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Drain the transmission fluid.
2. Remove the both oil filter cartridges by using a filter wrench.
3. Apply a slight coat of oil onto the new cartridge gasket.
4. To install the new cartridge, screw it in by hand.
tightening may cause deformation of rubber gasket.
5. After the new cartridge has been replaced, the transmission
fluid level will normally decrease slightly. Make sure that the
transmission fluid does not leak through the seal. Check the
fluid level.
A To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
(1) Drain Plug
(2) Hydraulic Oil Filter
Changing Front Axle Case Oil
A Be sure to stop the engine before changing the front axle
case oil.
A Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the both right and left drain plugs (2) at bottom of the
bevel gear case.
2. Drain the front axle case oil.
3. After draining, screw in the two drain plugs.
4. Fill new oil from filling port with specified amount.
A Use KUBOTA SUPER UDT fluid or SAE 80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT" (See
page G-8.)
A Oil level is at the center of the front axle.
Front axle case oil Capacity
(1) Filling Plug
(2) Drain Plug
G-16
GENERAL
(3) Hydraulic Oil Filter (for HST)
0000007970E
4.0 L
1.06 U.S.gals.
0.88 Imp.gals.
A : Oil Level
0000007971E
KiSC issued 04, 2006 A
Over