Kubota WSM STV32 Workshop Manual page 184

STV32 · STV36 · STV40, WSM
Cruise Control Linkage
A Execute this adjustment after the adjustment of maximum
traveling speed.
1. Engage the cruise control lever (1) to the most forward
position, and measure the clearance A between the pedal (2)
and the frame.
2. If the measurement is not within the factory specifications,
change the length L of the cruise control rod (3) to adjust.
Clearance A Factory spec.
Length L Reference value
(1) Cruise Control Lever
(2) Speed Control Pedal (Forward)
(3) Cruise Control Rod
Operation Check of Cruise Control Automatic Release
1. Engage the cruise control lever (1) and confirm the following
operations.
2. The cruise control lever (1) should return to the home position,
when right and left brake pedals are pressed at the same time.
3. The cruise control lever (1) must not return when only one of
brake pedals is pressed
4. When not operating like the above-mentioned, execute the
following checks "1) Lever Setting Position", "2) Release
Wire" and "3) Brake Link".
(1) Cruise Control Lever
(2) Brake Pedal
3-S13
TRANSMISSION
5 to 10 mm
0.20 to 0.39 in.
218.2 in.
8.59 in.
A: Clearance
L: Length
0000007523E
(3) Pedal Lock
0000007524E
KiSC issued 04, 2006 A