Disassembling And Assembling; Hydraulic Pump (Power Steering And 3P Hydraulic System) - Kubota WSM STV32 Workshop Manual

Table of Contents

Advertisement

STV32 · STV36 · STV40, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Hydraulic Pump (Power Steering and 3P Hydraulic System)

A The hydraulic pump is precision machined and assembled: if disassembled once, it may be unable to
maintain its original performance. Therefore, when the hydraulic pump fails, replacement should be
carried out with the hydraulic pump assembled except when emergency repair is unavoidable.
A When repair is required, follow the disassembly and servicing procedures shown below with utmost
care.
A Be sure to test the hydraulic pump with a flowmeter before disassembling.
A After reassembly, be sure to perform break-in operation and ensure that there is nothing abnormal with
the hydraulic pump.
Adjusting Position Control Lever Operating Force
1. Set a spring balance to the position control lever (1) to
measure the operating force.
2. If the measurement is not within the factory specification,
loosen the lock nut (3) and adjust the operating force with
position control lever mounting nut (2).
(When reassembling)
A Be sure to tight the lock nut.
Position control lever
Factory spec.
operating force
(1) Position Control Lever
(2) Mounting Nut
8-S15
HYDRAULIC SYSTEM
25 to 34 N
2.6 to 3.5 kgf
5.6 to 7.6 lbs
(3) Lock Nut
0000007852E
0000007853E
KiSC issued 04, 2006 A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wsm stv36Wsm stv40Stv32Stv36Stv40

Table of Contents