Kubota WSM STV32 Workshop Manual page 359

STV32 · STV36 · STV40, WSM
PTO Relay
1. Turn the main switch off and remove the PTO relay (1).
2. Apply battery voltage across 1 and 2 terminals, and check for
continuity across 3 and 5 terminals.
3. If continuity is not established across 3 and 5 terminal, renew
the PTO relay.
(1) PTO Relay
Glow Relay
1. Turn the main switch off and remove the glow relay (1).
2. Apply battery voltage across 3 and 4 terminals, and check for
continuity across 1 and 2 terminals.
3. If continuity is not established across 1 and 2 terminals, renew
the glow relay.
A The glow relay and the key stop relay are the same parts.
(1) Glow Relay
9-S18
ELECTRICAL SYSTEM
0000007933E
0000007934E
KiSC issued 04, 2006 A