Kubota WSM STV32 Workshop Manual page 281

STV32 · STV36 · STV40, WSM
Removing Steering Controller
1. Disconnect the delivery hose (5), delivery hose LH (3),
delivery hose RH (2) and charge hose (4).
2. Remove the mounting screws (1) and separate the steering
controller (6).
(When reassembling)
A Apply transmission oil to the oil seal (12).
A Align the pipe joint (11) to the ditch of the steering controller
(6).
A Connect the delivery hose RH (2) to the LT port (10).
A Connect the delivery hose LH (3) to the RT port (9).
A Assemble the delivery hose (5), delivery hose LH (3) and
delivery hose RH (2) so that each hose becomes parallel to the
hose joint (7).
A Be sure to check the hose joints de not interfere in other joints.
A The edge of the hose joint (7) should be corresponding to
the edge of the controller. (See figure)
Delivery hose RH (2)
retaining nut
Delivery hose LH (3)
retaining nut
Charge hose (4)
Tightening torque
retaining nut
Delivery hose (5)
retaining nut
(Controller side)
Delivery hose (5) joint
screw
(Pump side)
(1) Mounting Screw
(2) Delivery Hose RH
(3) Delivery Hose LH
(4) Charge Hose
(5) Delivery Hose
(6) Steering Controller
(7) Hose Joint (OUT port)
(8) Hose Joint (IN port)
7-S5
STEERING
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
34.3 to 44.1
3.5 to 4.5
25.3 to 32.5 ft-lbs
49 to 58.8
5.0 to 6.0
36.2 to 43.4 ft-lbs
(9) Hose Joint (RT port)
(10) Hose Joint (LT port)
(11) Pipe Joint
(12) Oil Seal
A : Viewed from Bottom Side
F : Front Side
R : Rear Side
0000007799E
KiSC issued 04, 2006 A