Kubota WSM STV32 Workshop Manual page 200

STV32 · STV36 · STV40, WSM
HST Linkage
1. Remove the return spring (1).
2. Remove the neutral holder (7) and holder shaft (8).
3. Remove the neutral cam (2) and HST link rod (6).
4. Remove the HST pedal rod (3).
5. Remove the link support (4) with the cruise control rod (5).
(When reassembling)
A Assemble the holder shaft (8) temporarily so that the angle (a)
of the groove becomes a reference value.
A Execute "Adjusting Neutral" (See page 3-S10) after all
assemblies ends.
Angle of the groove (a) Reference Value
(1) Return Spring
(2) Neutral Cam
(3) HST Pedal Rod
(4) Link Support
(5) Cruise Control Rod
HST Pedal and Pedal Support
1. Remove the screw (4) and nut (2), and remove the pedal
support assembly (3) with the brake switch.
2. Remove the speed control pedal (1).
(1) Speed Control Pedal
(2) Nut
3-S29
TRANSMISSION
1.80 rad
103
(6) HST Link Rod
(7) Neutral Holder
(8) Holder Shaft
a: Groove Angle
0000007553E
(3) Pedal Support Assembly
(4) Screw
0000007554E
KiSC issued 04, 2006 A