Kubota WSM STV32 Workshop Manual page 185

STV32 · STV36 · STV40, WSM
1) Lever Setting Position (Cruise Control)
1. Engage the cruise control lever (1).
2. Confirm the release lever (2) touches the cruise control lever
(1) by the spring (6), and the cruise control lever (1) touches
the stopper (5).
3. When not becoming like the above mentioned, check the
release wire (8) and damage of the spring (6). (See "Release
Wire".)
4. Check the clearance A between the claw (3) and lever guide
(4).
5. Check the projection height H of the claw (3) from the lever
guide (4).
6. If the clearance A is not within the factory specifications,
remove the left rear wheel and the fender cover, and adjust it
with the shim (7).
7. If the projection height H is not within the factory
specifications, loosen the screws (9) and move the cruise
lever assembly.
Clearance A between
the claw and lever guide
Factory spec.
Projection height H from
the lever guide
(Reference)
A Thickness of the shim (7): 1.0 mm (0.039 in.)
(1) Cruise Control Lever
(2) Release Lever
(3) Claw
(4) Lever Guide
(5) Stopper
(6) Spring
2) Release WIre (Cruise Control)
1. Remove the left rear wheel and the fender cover.
2. Engage the cruise control lever (1).
3. Check the inner wire in the release wire (5) does not slacken.
4. Check the release lever (6) touches the cruise control lever (1)
by the spring (3), and the cruise control lever (1) touches the
stopper (2).
5. When not becoming like the above-mentioned, adjust with the
adjusting nut (4).
(Reference)
A If the inner wire is too tight, the cruise control lever (1) does not
touch the stopper (2).
(1) Cruise Control Lever
(2) Stopper
(3) Spring
3-S14
TRANSMISSION
0 to 1 mm
0 to 0.039 in.
More than 2 mm (0.079 in.)
(7) Shim
(8) Release Wire
(9) Screw
A : Clearance between the claw
and lever guide
H : Projection height from the
lever guide
0000007525E
(4) Adjusting Nut
(5) Release Wire
(6) Release Lever
0000007526E
KiSC issued 04, 2006 A