Kubota WSM STV32 Workshop Manual page 28

STV32 · STV36 · STV40, WSM
Replacing Engine Oil Filter Cartridge
A Be sure to stop the engine before changing oil filter
cartridge.
A Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter cartridge with the filter wrench.
2. Apply a slight coat of oil onto the rubber seal of new filter.
3. To install the new cartridge, screw it in by hand.
tightening may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does
not leak through the seal and be sure to read the oil level on
the dipstick. Then, replenish the engine oil up to the specified
level.
A To prevent serious damage to the engine, replacement
filter must be highly efficient.
genuine filter or its equivalent.
(1) Engine Oil Filter
G-14
GENERAL
Over
Use only a KUBOTA
0000007968E
KiSC issued 04, 2006 A