Kubota WSM STV32 Workshop Manual page 262

STV32 · STV36 · STV40, WSM
Front Wheel Turning Angle Sensor
1. Remove the wire harness clamp (2).
2. Disconnect the connector (1).
3. Remove the cotter pin and disconnect the arm (4) from the
sensor lever (3).
A Route the wire harness under the both power steering
hoses.
(1) Connector
(2) Clamp
Front Wheels and Steering Cylinder Hoses
1. Lift up the front side of tractor and place the disassembling
stand under the front axle frame.
2. Remove the front wheels.
3. Disconnect the delivery hoses (1) (3).
A After disconnect the delivery hoses, do not steer the front
axle so that the steering oil may come out from the
delivery hoses.
A Connect the delivery hoses to the original position.
(When reassembling)
A The power delivery hose RH (1) with white tape (4) to connect
the right side connector of steering cylinder (2).
A Be sure to assemble the delivery hose RH and LH as shown
in figure.
Front wheel mounting
screw and nut
Tightening torque
Delivery hose retaining
nut
(1) Delivery Hose RH
(2) Steering Cylinder
(3) Delivery Hose LH
Front Axle Assembly
1. Place the disassembling stand under the front axle.
2. Remove the front axle brackets (Front and Rear) mounting
screws.
3. Separate the front axle from the front axle frame.
(When reassembling)
A After mounting the front axle assembly to the front axle frame,
be sure to adjust the front axle rocking force. (See page 6-S5.)
Front axle bracket
Tightening torque
mounting screw
(1) Rear Axle Bracket
6-S6
FRONT AXLE
(3) Lever
(4) Arm
0000007625E
77.5 to 90.2
7.9 to 9.2
57.1 to 66.5 ft-lbs
25 to 30
2.5 to 3.0
18.1 to 21.7 ft-lbs
(4) White Tape
A: 0.785 rad (45 )
0000007626E
200 to 230
20.4 to 23.5
147.5 to 169.6 ft-lbs
(2) Front Axle Bracket
0000007627E
KiSC issued 04, 2006 A