Separating Hst (Hydrostatic Transmission); Separating Mid Case; Separating Transmission Case - Kubota WSM STV32 Workshop Manual

STV32 · STV36 · STV40, WSM

(3) Separating HST (Hydrostatic Transmission)

(4) Separating Mid Case

(5) Separating Transmission Case

Separating HST (Hydrostatic Transmission)
1. Place a disassembly stand under the HST (2) and mid case
(1).
2. Remove the HST mounting screw and nuts to separate the
HST (2) from the mid case (1).
A Do not pull out the front drive shaft (3) when you do not
separate the mid case (1).
(When reassembling)
A Apply liquid gasket (Three Bond 1208D or equivalent) to the
joint face of the HST and mid case.
HST mounting screw
Tightening torque
and nut
(1) Mid Case
(2) HST (Hydrostatic
Transmission)
Separating Mid Case
1. Remove the counter shaft and coupling (2).
2. Remove the mid case mounting screws and nuts to separate
the mid case (1) from the transmission case.
(When reassembling)
A Apply liquid gasket (Three Bond 1208D or equivalent) to the
joint face of the mid case and transmission case.
Mid case mounting
Tightening torque
screw and nut
(1) Mid Case
3 Point Linkage and Drawbar
1. Remove the lifting rods (1) (4).
2. remove the top link (3) and PTO shaft cover (2).
3. Remove the lower links (5) (7) with the check chains.
4. Pill out the drawbar (6).
(1) Lifting Rod (Left)
(2) PTO Shaft Cover
(3) Top Link
(4) Lifting Rod (Right)
3-S31
TRANSMISSION
39.3 to 44.1
4.0 to 4.5
29.0 to 32.5 ft-lbs
(3) Front Drive Shaft
0000007530E
39.3 to 44.1
4.0 to 4.5
29.0 to 32.5 ft-lbs
(2) Counter Shaft and Coupling
0000007533E
(5) Lower Link (Right)
(6) Drawbar
(7) Lower Link (Left)
0000007534E
KiSC issued 04, 2006 A