Kubota WSM STV32 Workshop Manual page 95

STV32 · STV36 · STV40, WSM
Power Steering Hoses and Accelerator WIre (Right Side)
1. Remove the cushion rubber (4) noting not to damage it.
2. Disconnect the accelerator wire (5) from the engine.
3. Remove the power steering delivery hose (6).
A Do not lose the check valve and spring in the pump side
joint.
4. Disconnect the delivery hose LH (1) and delivery hose RH (2)
from the steering controller.
5. Loosen the clamp and disconnect the suction hose (3) from
the hydraulic pump.
(When reassembling)
A Connect the delivery hose RH (2) to the LT port (9).
A Connect the delivery hose LH (1) to the RT port (8).
A Assemble the delivery hose (6), delivery hose LH (1) and
delivery hose RH so that each hose becomes parallel to the
hose joint (11).
A Be sure to check the hose joints do not interfere in other joints.
Delivery hose RH (2)
Tightening torque
retaining nut
Delivery hose LH (1)
Tightening torque
retaining nut
Delivery hose (6)
Tightening torque retaining nut
(Controller side)
Delivery hose (6) joint
Tightening torque screw
(Pump side)
(1) Delivery Hose LH
(2) Delivery Hose RH
(3) Suction Hose
(4) Cushion Rubber
(5) Accelerator Wire
(6) Delivery Hose
(7) Steering Controller
(8) RT Port
1-S23
ENGINE
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
34.3 to 44.1
3.5 to 4.5
25.3 to 32.5 ft-lbs
49 to 58.8
5.0 to 6.0
36.2 to 43.4 ft-lbs
(9) LT Port
(10) Charge Hose
(11) Hose Joint (OUT Port)
[A] Viewed from Bottom Side
F: Front Side
R: Rear Side
0000007486E
KiSC issued 04, 2006 A