Kubota WSM STV32 Workshop Manual page 199

STV32 · STV36 · STV40, WSM
Clutch and Brake Linkage
1. Remove the brake rods (1) (7) and brake springs (6).
2. Remove the release wire (11).
3. Remove the brake link (10).
4. Remove the spring pin (8) and external snap ring (9), and
remove the brake pedals (4) (5).
5. Remove the clutch rod and spring (2), and draw out the clutch
pedal (3) with the brake shaft.
6. Remove the damper (14).
7. Remove the parking brake shaft assembly (12) with the
parking brake rod 1 (13) and parking brake rod 2 (15).
(When reassembling)
A Reassemble the release wire (11) to the guide plate (16) so
that the guide plate (16) comes to the center of the threaded
portion.
A Apply grease to the brake link (10).
A After reassembling the brake link (10), execute the check of
"3) Brake Link (Cruise Control)" (See page 3-S15).
A Adjust the clutch pedal free travel (See page 2-S5).
A Adjust the brake pedal free travel (See page 5-S3).
A Adjust the parking brake lever free travel (See page 5-S4).
Clutch pedal free travel
Brake pedal free travel
Factory spec.
Parking brake lever free
travel
Tightening torque Brake link retaining nut
(1) Brake Rod (Left)
(2) Clutch Spring
(3) Clutch Pedal
(4) Brake Pedal (Left)
(5) Brake Pedal (Right)
(6) Brake Spring
(7) Brake Rod (Right)
(8) Spring Pin
3-S28
TRANSMISSION
20 to 30 mm
0.78 to 1.18 in.
20 to 30 mm
0.78 to 1.18 in.
The brake works when the
lever is raised until the
rachet sound is heard
twice.
7.8 to 9.3
0.8 to 0.95
5.8 to 6.9 ft-lbs
(9) External Snap Ring
(10) Brake Link
(11) Release Wire (Cruise Control)
(12) Parking Brake Shaft Assembly
(13) Parking Brake Rod 1
(14) Damper
(15) Parking Brake Rod 2
(16) Guide Plate
0000007552E
KiSC issued 04, 2006 A