STV32 · STV36 · STV40, WSM
Separating Rear PTO Case and Mid PTO Case
1. Remove the drawbar bracket (3).
2. Remove the mounting screws and pull out the rear PTO case
(1) with the gears and shafts on it.
3. Remove the mid PTO case (4).
4. Take out the 24T gear (6) and bearing (7) from the
transmission case.
(When reassembling)
A Install the rear PTO case (1) while inserting the mid PTO drive
shaft (5) into the 24T gear (6) and bearing (7).
A Apply liquid gasket (Three Bond 1208D or equivalent) to the
joint face of the transmission case, rear PTO case (1) and mid
PTO case (4).
Rear PTO case
Tightening torque
mounting screw
Mid PTO case mounting
Tightening torque
screw
(1) Rear PTO Case
(2) PTO Shaft Cover
(3) Drawbar Bracket
(4) Mid PTO Case
3-S45
TRANSMISSION
39.3 to 44.1
4.0 to 4.5
29.0 to 32.5 ft-lbs
29.4 to 34.3
3.0 to 3.5
21.7 to 25.3 ft-lbs
(5) Mid PTO Drive Shaft
(6) 24T Gear
(7) Bearing
0000007585E
KiSC issued 04, 2006 A