Brake Light Switch - Kubota WSM STV32 Workshop Manual

STV32 · STV36 · STV40, WSM

(19)Brake Light Switch

Brake Light Switch Continuity
1. Disconnect the 2P connector (1), and measure the resistance
with an ohmmeter across the brake switch leads.
2. If the measurement still differs from the table, replace the
brake light switch.
Resistance
(When the switch push a - b
is released)
Resistance
(When the switch push a - b
is pushed)
A Brake pedal free travel : 20 to 30 mm (0.79 to 1.18 in.).
(1) 2P connector
Adjusting Brake Light Switch
1. Disconnect the connector (1) and remove the brake light
switch (2) once.
2. Depress the brake within the range of free travel (20 to 30 mm
(0.79 to 1.18 in.)) and hold it.
3. Connect the leads of the ohmmeter to the brake light switch
lead terminal.
4. Screw in the brake light switch (2) until the ohmmeter begins
to show "Infinity".
5. Further screw in the brake light switch by 1/2 turn and tighten
the lock nut (3).
(1) Connector
(2) Brake Light Switch
9-S28
ELECTRICAL SYSTEM
0
Infinity
(2) Brake Light Switch
0000007948E
(3) Lock Nut
0000008029E
KiSC issued 04, 2006 A