Kubota WSM STV32 Workshop Manual page 93

STV32 · STV36 · STV40, WSM
Steering Wheel
1. Remove the covers (3).
2. Remove the steering wheel cap.
3. Remove the steering wheel mounting nut (1) and remove the
steering wheel (2) with a steering wheel puller (Code No.
07916-51090).
(When reassembling)
Steering wheel
Tightening torque
mounting nut
(1) Nut
(2) Steering Wheel
Meter Panel and Panel Under Cover
1. Open the meter panel (1) and disconnect the meter panel
connector (2) and hour-meter cable (3). Then remove the
meter panel.
2. Remove the sponge.
3. Disconnect the combination switch connector (4), main switch
connector (5), hazard switch connector (7) and position lamp
switch connector (8).
4. Remove the panel under cover (6)
(1) Meter Panel
(2) Meter Panel Connector
(3) Hour-meter Cable
(4) Combination Switch Connector
Panel Under Frame
1. Remove the foot cover (2).
2. Remove the screws (3) and nuts (4), and pull up the panel
under frame (1).
(When reassembling)
A When reassembling the panel under frame, tighten the two
nuts (4) for insulation rubber first.
(1) Panel Under Frame
(2) Foot Cover
1-S21
ENGINE
48.1 to 55.9
4.9 to 5.7
35.4 to 41.2 ft-lbs
(3) Cover
0000007481E
(5) Main Switch Connector
(6) Panel Under Cover
(7) Hazard Switch Connector
(8) Position Lamp Switch
Connector
0000007482E
(3) Screw
(4) Nut
0000007483E
KiSC issued 04, 2006 A