Disassembling And Assembling - Kubota WSM STV32 Workshop Manual

STV32 · STV36 · STV40, WSM

[3] DISASSEMBLING AND ASSEMBLING

Clutch Assembly
1. Remove the clutch mounting screws and remove the clutch
assembly (1) from the flywheel.
(When reassembling)
A Direct the shorter end of the clutch disc boss toward the
flywheel.
A Apply molybdenum disulphide (Three Bond 1901 or
equivalent) to the splines of clutch disc boss.
A Screws in two reamer screws (3) in the reamer screw holes.
A After tighten the reamer screws, tighten the other general
screws.
A Align the center of clutch disc and flywheel by inserting
the clutch center tool (2).
A Do not allow grease and oil on the clutch disc facing.
A The reamer screw hole on the clutch cover (7) is in the
next of the 5 mm (0.2 in.) dia. hole (4).
A The shape of the reamer screw hole (8) on the flywheel is
different from other screw holes.
Tightening torque Clutch mounting screw
(1) Clutch Assembly
(2) Clutch Center Tool
(3) Reamer Screw
(4) 5 mm dia. Hole
2-S5
CLUTCH
23.5 to 27.5
2.4 to 2.8
17.4 to 20.2 ft-lbs
(5) Flywheel
(6) Clutch Disc
(7) Clutch Cover
(8) Screw Hole for Reamer Screw
0000007493E
KiSC issued 04, 2006 A