Kubota WSM STV32 Workshop Manual page 120

STV32 · STV36 · STV40, WSM
Replacing Valve Guide
(When removing)
1. Press out the used valve guide using a valve guide replacing
tool.
(When installing)
1. Clean a new valve guide and valve guide bore, and apply
engine oil to them.
2. Press in a new valve guide using a valve guide replacing tool.
3. Ream precisely the I.D. of the valve guide to the specified
dimension.
Valve guide I.D. (Intake
Factory spec.
and exhaust)
A Do not hit the valve guide with a hammer during
replacement.
(A) When Removing
Valve Seating
1. Coat the valve face lightly with prussian blue and put the valve
on its seat to check the contact.
2. If the valve does not seat all the way around the valve seat or
the valve contact is less than 70 %, correct the valve seating
as follows.
3. If the valve contact does not comply with the reference valve,
replace the valve or correct the contact of valve seating
(1) Correct
(2) Incorrect
1-S48
ENGINE
8.015 to 8.030 mm
0.31555 to 0.31614 in.
(B) When Installing
0000005442E
(3) Incorrect
0000004342E
KiSC issued 04, 2006 A