Concluding Steps; Replacing A Heat Sink; Preliminary Steps; Removing The Defective Heat Sink - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

Processors

11.3.7 Concluding steps

"Installing the air duct" on page 62
Ê
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 57
Ê
"Updating or recovering the system board BIOS and iRMC" on page 70
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 58
Ê
"Enabling BitLocker functionality" on page 83
Ê
11.4

Replacing a heat sink

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

11.4.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 47
Ê
"Getting access to the component" on page 47
Ê
"Removing the air duct" on page 62
Ê

11.4.2 Removing the defective heat sink

Ê Remove the heat sink as described in section
page 223.
Ê Remove the residual thermal paste from the processor surface.
Ê Clean the processor surface using a lint-free cloth.
232 Upgrade and Maintenance Manual
Hardware: 15 minutes
"Removing the heat sink" on
RX200 S8