Preliminary Steps; Removing A Power Supply Unit - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

Power supply
6.3.1

Preliminary steps

No steps needed.
6.3.2

Removing a power supply unit

Ê Remove the power cord from the dedicated power supply unit as described
in section "Disconnecting the server from the mains" on page 47
I
Keep the power cord for future use.
Figure 30: Unlocking and removing the power supply unit
Ê Push the handle of the power supply unit halfway upward in the direction of
the arrow (1).
Ê Push the lock in direction of the arrow (2).
Ê Grip the handle and pull out the power supply unit in the direction of the
arrow (3).
V
CAUTION!
Never leave the bay for the power supply unit empty for more than two
minutes during operation. Otherwise, excessive temperatures could
damage system components.
98 Upgrade and Maintenance Manual
RX200 S8