Basic hardware procedures
4.4.1
Extending the server out of the rack
V
CAUTION!
Use the anti-tilt plate to prevent the rack from tipping when installing
●
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
Be careful not to pinch fingers or clothes when sliding out the server
●
or pushing it back. Failure to do so may cause injury.
For further safety information, please refer to chapter
●
information" on page
Ê Remove all remaining external cables from the rear connector panel and
expansion cards.
Ê If you are not using a cable mounting arm (CMA kit), ensure that the rear
cables are long enough not to be strained or damaged when extending the
server out of the rack.
Figure 3: Extending the server out of the rack
Ê Fold down the two quick release levers (1) and pull the server out of the rack
until it locks in place (2).
V
CAUTION!
Do not use the extended server as a surface on which to put things
or as a work surface, and strictly avoid leaning on or against it.
48
31.
Upgrade and Maintenance Manual
"Important
RX200 S8