Software Configuration; Removing The Ufm; Preliminary Steps - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

System board and components

15.3.1.4 Software configuration

The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.

15.3.2 Removing the UFM

Field Replaceable Unit
(FRU)
Tools: – Phillips PH1 / (+) No. 1 screw driver
– combination pliers and flat nose pliers

15.3.2.1 Preliminary steps

"Disabling SVOM boot watchdog functionality" on page 64
Ê
"Disabling BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 47
Ê
"Getting access to the component" on page 47
Ê
"Removing the riser module 3" on page 60
Ê
284 Upgrade and Maintenance Manual
Hardware: 5 minutes
RX200 S8