Installing The New System Board - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

I
Returned system boards without this cover probably have to be
scrapped.

15.6.3 Installing the new system board

Ê Install the processor as described in section
on page 227).
Ê Check the settings on the new system board (see section
settings" on page
Ê Insert the system board by holding it at a slight angle. Slide the connectors
into the connector panel (see figure
Ê Lower the system board carefully into the chassis.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion.
I
When the system board is in the right position, the centre rings engage
with the holes indicated.
Ê Fasten the system board with the nine screws (see figure
Ê Install the distance holder (see figure
RX200 S8
334).
Upgrade and Maintenance Manual
System board and components
"Installing the new processor"
239 on page 308).
237 on page 307).
"Onboard
238 on page 307).
309