Replacing A Processor; Preliminary Steps - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

Processors
"Updating or recovering the system board BIOS and iRMC" on page 70
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 58
Ê
"Enabling BitLocker functionality" on page 83
Ê
11.3

Replacing a processor

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
Processors are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a
processor has been removed from its protective sleeve or from its
socket, place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.

11.3.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Disabling SVOM boot watchdog functionality" on page 64
Ê
"Disabling BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 47
Ê
"Getting access to the component" on page 47
Ê
"Removing the air duct" on page 62
Ê
222 Upgrade and Maintenance Manual
Hardware: 15 minutes
Software: 5 minutes
RX200 S8