Concluding Steps - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

Figure 38: Connecting the power cables
Ê Connect the two power cables to the connector "PWR 2" (1) and connector
"PWR 1" (2) of the system board.
Ê Install all power supply units you removed beforehand as described in
section "Installing the power supply unit" on page
6.5.4

Concluding steps

Perform the following procedures:
"Installing the riser module 3" on page 61
Ê
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 57
Ê
"Switching on the server" on page 58
Ê
"Enabling BitLocker functionality" on page 83
Ê
RX200 S8
Upgrade and Maintenance Manual
Power supply
94.
105