W E Reserve The Right To Change Execution And Construction - Meiko K-Tronic Service Manual

Service Instructions Dishwashing Machine Model K-Tronic
515 Thermal contact
compressor
Low temperature
610
drying zone
Drying temp. sensor
611
short cut
Drying temp. sensor
612
break
Drying fan error
613
Excessive temperature
614
Drying
615 Suction fan
malfunction
End switch activated
710
711 Error impulse
transmitter transport
Malfunction
713
rinse agent
Malfunction detergent
714
Malfunction gas
715
module
External water
716
treatm. malfunction
External conveyor
717
KMM connection
815
interrupted
Datei: 2K_9628652_Serviceanleitung-MIKE_EN_2005-09-01.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
Thermal contact on compressor has
triggered
Drying
Tolerance range exceeded
Short circuit drying temperature sensor.
Short circuit in the wiring; damp in the
connector.
Cable to drying temperature sensor
broken.
Connector incorrectly connected;
crimp connection inadequate
Motor overload switch fan triggered
Permissible maximum exceeded
Suction fan power switch triggered
Conveyor system
Crockery at the conveyor end
If the impulse switch mode is
PARAMETERISE d and the transport
activated, a cycle impulse must be
received for each time unit; in the event
of an error, the units are switched to
continuous running
Reed switch defective; Magnet on rotary
disk incorrectly positioned
Rinse agent empty?
Detergent empty?
See gas module description
See description of the water treatment
equipment
see circuit diagram description
CAN communication
CAN connection interrupted;
KMM (communication module) does not
respond
valid from: 2005-09-01 Update: 2006-11-14 / S.5

W e reserve the right to change execution and construction!

Find cause for raised
temperature
Malfunction must also be
acknowledged in addition
Remove crockery
Page 26/30
Ident No.: 9627429