W E Reserve The Right To Change Execution And Construction; Access To The Parameter Setting Level - Meiko K-Tronic Service Manual

Service Instructions Dishwashing Machine Model K-Tronic
Datei: 2K_9628652_Serviceanleitung-MIKE_EN_2005-09-01.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
in quick succession (e.g. 5 values per second) until the key is released.
When in editing mode, the present parameter value flashes slowly to indicate the
current parameter setting. If no key is pressed for a specific period, the parameter level
is automatically left and the appliance reverts to "Machine OFF" status. All the other
functions of the appliance are blocked while this dialogue is shown.
7.1

Access to the parameter setting level

Note on the code entry:
The code entered is compared with an internal code table after complete entry. The
corresponding selection menu items are enabled, depending on the code entered.
2 access codes are stored for each user level; the first is for restricted access, i.e. it is
not possible to change the parameters (view mode), the second enables the complete
functional scope (changing values).
The access code for the technician level incorporates the user level.
Starting point: Machine OFF
1. Access: Press the
seconds. You will then be asked to enter
the access code:
2. Enter the access code (5 figures):
The cursor appears at the 1
appears and flashes)
Use the or keys to move the
first figure to the required value.
Use the and keys to move to the next position. Code entry is concluded by
pressing the . key after entering all the required figures.
In the following the user level is indicated
on the top right showing the
corresponding number of the level.
valid from: 2005-09-01

W e reserve the right to change execution and construction!

* PARAMETERISE
key for 2
Please enter code
* PARAMETERISE
st
figure (0
Please enter code
* PARAMETERISE
Update: 2006-11-14 / S.5
Machine off
10.3.06 10:13
****
****
Parameter
Ident No.: 9627429
*
*
* 2
Page 14/30