W E Reserv E The Right To Change Execution And Construction - Meiko K-Tronic Operating Instructions Manual

Dishwashing machine

Hide thumbs Also See for K-Tronic:

Service manual (248 pages)

Operating instructions manual (58 pages)

Table Of Contents

Table of Contents

Operating instructions dishwashing machine model K-Tronic

Maintenance

VERY IMPORTANT:

3. Wash systems

Check ascending pipe for watertightness

- Pump / ascending pipe connection

- Ascending pipe

- Ascending pipe / wash system connection

- Wash system seating

Check wash system

Check wash system for damage

Check nozzles for cleanliness

Check that the correct number of wash pipe end caps is present

Check the spray pattern (the whole width of the belt must be covered by

the spray).

The pressure from the lower spray must be controlled so that the lightest

dish does not rotate

4. Clean water rinse system

Check motor power switch (if present)

Check motor for exterior damage

(

Check current consumption

Check motor for quiet running (bearing damage)

Check ventilation grid for cleanliness

Check pump power switch (if present)

Check sliding ring seal for watertightness (external visual check)

Replace sliding ring seal

Check pump impeller for damage

Check pump housing for damage

System

Check the complete system for damage and watertightness

Check nozzles for cleanliness

Check water quantity (use the water meter or measure manually)

Clean the inlet tank

Check float switch function

Datei:BA-K-tronic_MIKE_9626212_EN_2005-12-01.doc

MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121

Whenever any electrical components are disconnected and

reconnected, replaced or repaired, a safety test must be

conducted, at least on these components!!!

see wiring diagram)