3Com SuperStack 4 Configuration Manual page 369

SSH Configuration
Example
1 You should run this command before any other configuration:
2 For password authentication mode
Log out of SSH connection with the
Displaying and Debugging SSH
Run the command in any view to view the running of SSH and further to
display
check configuration result.
Run the command to debug the SSH.
debugging
Perform the following configurations in any view.
Table 457 Display SSH Information
Operation
Display host and server public keys display rsa local-key-pair public
Display client RSA public key
Display SSH state information and
session
Display SSH user information
Enable SSH debugging
Disable SSH debugging
Networking Requirements
As shown in Figure 105, configure a local connection from the SSH Client to the
Switch. The client uses SSH protocol to access the Switch.
Networking Diagram
Figure 105 Networking for SSH Local Configuration
SSH Client SSH Client
Configuration Procedure
[SW5500]rsa local-key-pair create
If you have configured local key pair in advance, this operation is unnecessary.
[SW5500]user-interface vty 0 4
[SW5500-ui-vty0-4]authentication-mode scheme
[SW5500-ui-vty0-4]protocol inbound ssh
[SW5500]local-user client001
[SW5500-luser-client001]password simple 3com
[SW5500-luser-client001]service-type ssh
[SW5500]ssh user client001 authentication-type password
Select the default values for SSH authentication timeout value, retry value and
update interval of server key. Then run SSH1.5 client program on the PC which is
command.
logout
Command
display rsa peer-public-key [ brief |
keyname
name ]
display ssh server { status | session }
display ssh user-information [
debugging ssh server { VTY
undo debugging ssh server { VTY
all }
Switch Switch
SSH Terminal Services 381
username
index
| all }
index
|
]