3Com SuperStack 4 Configuration Manual page 322

334 C 12: F S
HAPTER ILE YSTEM
M
ANAGEMENT
Table 396 Enable/Disable Info-Center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to Telnet terminal or dumb terminal
Perform the following operation in System View.
Table 397 Configuring to Output Information to Telnet Terminal or Dumb Terminal
Operation
Output information to Telnet terminal or dumb
terminal
Cancel the configuration of outputting
information to Telnet terminal or dumb terminal
3 Configuring information source on the Switch
With this configuration, you can define the information that is sent to the Telnet
terminal or dumb terminal that is generated by which modules, information type,
information level, and so on.
Perform the following operation in System View:
Table 398 Defining Information Source
Operation
Define information source info-center source {
Cancel the configuration
of information source
specifies the module name;
modu-name
refers to the severity levels;
The information with the level below it will not be output.
specifies the channel number and
When defining the information sent to Telnet terminal or dumb terminal,
or
channel-number
the Console direction.
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
When there are more than one Telnet users or monitor users at the same time,
some configuration parameters should be shared among the users, such as
module-based filtering settings and severity threshold. When a user modifies these
settings, it will be reflected on other clients.
Command
info-center enable
undo info-center enable
Command
channel-number
channel {
| trap | debug }* { level
}* ]
undo info-center source {
channel { channel-number
default
specifies the severity level of information.
severity
channel-name
must be set to the channel that corresponds to
channel-name
Command
info-center monitor channel {
channel-number | channel-name
undo info-center monitor
channel
modu-name | default }
|
channel-name
severity
| state
modu-name
| default }
| channel-name
represents all the modules;
channel-number
specifies the channel name.
}
} [ { log
state
}
level
default