Network Diagram - 3Com SuperStack 4 Configuration Manual

226 C 8: ACL C
HAPTER ONFIGURATION
QoS Profile
Configuration Example
Table 254 Displaying QoS Profile Configuration
Operation
Display QoS profile
configuration
Networking Requirement
The Switch implements the QoS profile function for the accessed user.
The user (with user name
accessed from the GigabitEthernet1/0/1 port into the Switch. The user is assigned
into the 3com163.net domain. The QoS profile example references the ACL with
bandwidth limited to 128 kbps and new DSCP preference value 46.

Network Diagram

Figure 55 Network Diagram for QoS Configuration
Configuration Procedure
1 Configuration on the AAA server
Configure on the AAA server the mapping between QoS profiles and user
names/authentication information. The configuration details are omitted here.
2 Configuration on the Switch
a Enable 802.1x
[SW5500]dot1x
[SW5500]dot1x interface ethernet 1/0/1
b Configure IP address for the RADIUS server
[SW5500]radius scheme radius1
[SW5500-radius-radius1]primary authentication 10.11.1.1
[SW5500-radius-radius1]primary accounting 10.11.1.2
[SW5500-radius-radius1]secondary authentication 10.11.1.2
[SW5500-radius-radius1]secondary accounting 10.11.1.1
c Configure authentication password on the RADIUS server for the Switch
[SW5500-radius-radius1]key authentication name
[SW5500-radius-radius1]key accounting money
d Configure the Switch to remove the user domain name from the user name
and then to transfer it to the RADIUS server
[SW5500-radius-radius1]user-name-format without-domain
Command
display qos-profile { all | name
interface_name
interface {
interface_num
} | user
and authentication password
someone
Network
Network
Switch
User
profile_name
interface_type
|
user_name
}
hello
AAA Server
|
) is