3Com SuperStack 4 Configuration Manual page 223

Displaying and
Debugging a Fabric
Fabric Configuration
Example
Following completion of the above configuration, you can execute the
command in any view to view device management and verify the settings.
Table 263 Displaying and Debugging FTM
Operation
Display the information of the entire Fabric
Display the topology information of Fabric
Networking Requirements
Configure unit ID, unit name, Fabric name, and authentication mode for four
Switches, and interconnect them to form a Fabric.
The configuration details are as follows:
Unit IDs: 1, 2, 3, 4
■
Unit names: unit 1, unit 2, unit 3, unit 4
■
Fabric name: hello
■
Authentication mode: simple password
■
Password: welcome
■
Networking Diagram
Figure 60 Networking Diagram of a Fabric
Configuration Procedure
Configure Switch A:
[SW5500]change unit-id 1 to 1
[SW5500]set unit 1 name unit1
[SW5500]sysname hello
Configure Switch B:
[SW5500]change unit-id 1 to auto-numbering
[SW5500}set unit 1 name unit2
[SW5500]sysname hello
Configure Switch C:
[SW5500]change unit-id 1 to auto-numbering
Fabric Configuration Example
Command
display xrn-fabric [ port ]
display ftm{ information |
route | topology-database }
Fabric Fabric Fabric Fabric
Switch A Switch A Switch B Switch B
Switch C Switch C Switch D Switch D
display
user port user port user port user port
Fabric port Fabric port Fabric port Fabric port
235