3Com SuperStack 4 Configuration Manual page 320

332 C 12: F S
HAPTER ILE
Sending the Information
to Control Terminal
M
YSTEM ANAGEMENT
Operation
Output time-stamp is disabled
4 Configuring loghost
The configuration on the loghost must be the same with that on the Switch. For
related configuration, see the configuration examples in the latter part of this
chapter.
To send information to the control terminal, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 391 Enable/disable info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to the control terminal.
Perform the following operation in System View.
Table 392 Configuring the Output Information to Control Terminal
Operation
Output information to Console
Cancel the configuration of
outputting information to Console
3 Configuring the information source on the Switch.
With this configuration, you can define the information sent to the control
terminal that is generated by which modules, information type, information level,
and so on.
Perform the following operation in System View:
Table 393 Defining Information Source
Operation
Define information source
Cancel the configuration of
information source
specifies the module name;
modu-name
refers to the severity levels;
The information with the level below it will not be output.
specifies the channel number and
Command
undo info-center timestamp { log |
trap | debugging }
Command
info-center enable
undo info-center enable
Command
info-center console channel{
channel-number
undo info-center console channel
Command
info-center source {
channel { channel-number
log | trap | debug }* { level
state state }* ]
undo info-center source {
channel-number
} channel {
default
specifies the severity level of information.
severity
channel-name
channel-name
| }
modu-name
| default }
| channel-name
severity
modu-name
| default
channel-name
|
represents all the modules;
channel-number
specifies the channel name.
} [ {
|
}
level