3Com SuperStack 4 Configuration Manual page 336

348 C 12: F S
HAPTER ILE
Setting the Engine ID of
a Local or Remote
Device
Setting/Deleting an
SNMP Group
Setting the Source
Address of Trap
Adding/Deleting a User
to/from an SNMP Group
M
YSTEM ANAGEMENT
Operation
Restore the default SNMP System
Information of the Switch
By default, the sysLocation is specified as a blank string, that is, "".
You can use the following commands to set the engine ID of a local or remote
device.
Perform the following configuration in System View.
Table 421 Set the Engine ID of a Local or Remote Device
Operation
Set the engine ID of the device
Restore the default engine ID of the device. undo snmp-agent local-engineid
By default, the engine ID is expressed as enterprise No. + device information. The
device information can be IP address, MAC address, or user-defined text.
You can use the following commands to set or delete an SNMP group.
Perform the following configuration in System View.
Table 422 Set/Delete an SNMP Group
Operation
Setting an SNMP group
Deleting an SNMP group
You can use the following commands to set or remove the source address of the
trap.
Perform the following configuration in System View.
Table 423 Set the Source Address of Trap
Operation
Set the source address of trap
Remove the source address of trap
You can use the following commands to add or delete a user to/from an SNMP
group.
Perform the following configuration in System View.
Command
undo snmp-agent sys-info [ { contact |
location }* | version { { v1 | v2c | v3 }*
| all } ]
Command
snmp-agent local-engineid
Command
snmp-agent group { v1 | v2c }
read-view
read-view
notify-view
] [ notify-view
snmp-agent group v3
authentication | privacy ] [ read-view
read-view ] [ write-view
[notify-view notify-view
undo snmp-agent group { v1 | v2c }
undo snmp-agent group v3
authentication | privacy ]
Command
snmp-agent trap source
interface-num
undo snmp-agent trap source
engineid
group-name
write-view
] [ write-view
acl-list
] [ acl
group-name
[
write-view ]
] [ acl acl-list
group-name
group-name
[
interface-name
[
]
]