Table of Contents
Advertisement
With this configuration, you can define the information that is sent to SNMP NM:
generated by which modules, information type, information level, and so on.
Perform the following operation in System View.
Table 411 Defining Information Source
Operation
Define information
source
Cancel the configuration
of information source
specifies the module name;
modu-name
refers to the severity levels;
The information with the level below it will not be output.
specifies the channel number and
When defining the information sent to SNMP NM,
must be set to the channel that corresponds to Console direction.
channel-name
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
debugging
source, meantime using the
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Table 412 Configuring the Output Format of Time-stamp
Operation
Configure the output format of the
time-stamp
Output time-stamp is disabled
4 Configuring SNMP and a network management workstation on the Switch
You have to configure SNMP on the Switch and the remote workstation to ensure
that the information is correctly sent to the SNMP NM. Then you can get correct
information from the network management workstation.
Turning on/off the Information Synchronization Switch in Fabric
After the forming of a Fabric by Switches which support XRN; the log, debugging
and trap information among the Switches is synchronous. The synchronization
process is as follows: each Switch sends its own information to other Switches in
the Fabric and meantime receives the information from others, and then the
Switch updates the local information to ensure the information synchronizes
within the Fabric.
Command
info-center source {
channel-number
channel {
trap | debug }* { level
undo info-center source {
channel {
channel-number
default
specifies the severity level of information.
severity
channel-name
as the information type when configuring information
command to turn on the debugging
debugging
Command
info-center timestamp { log | trap
| debugging } { boot | date | none }
undo info-center timestamp { log |
trap | debugging }
Logging Function
modu-name
| default }
channel-name
|
} [ { log |
severity
state
| state
modu-name
| default }
|
channel-name
}
represents all the modules;
channel-number
specifies the channel name.
or
channel-number
339
}* ]
level
default
- Quick Links:
- Configuration Guide
Hide quick links:
Advertisement
Table of Contents
