3Com SuperStack 4 Configuration Manual page 272

284 C 11: 802.1
HAPTER X
Setting the Supported
Type of the RADIUS
Server
Setting the RADIUS
Server State
C
ONFIGURATION
Table 321 Setting Retransmission Times of RADIUS Request Packet
Operation
Set retransmission times of RADIUS request packet
Restore the default value of retransmission times
By default, RADIUS request packet will be retransmitted up to three times.
The Switch 5500G-EI supports the standard RADIUS protocol and the extended
RADIUS service platforms.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS Scheme View.
Table 322 Setting the Supported Type of the RADIUS Server
Operation
Setting the Supported Type of RADIUS Server
Restore the RADIUS server type to the default setting
By default, the newly created RADIUS scheme supports the server type
while the "system" RADIUS scheme created by the system supports the server
type .
3com
For the primary and secondary servers (no matter if they are an
authentication/authorization server or accounting server), if the primary server is
disconnected from the NAS for some fault, the NAS will automatically turn to
exchange packets with the secondary server. However, after the primary server
recovers, the NAS will not resume the communication with it at once, instead, it
continues communicating with the secondary server. When the secondary server
fails to communicate, the NAS will turn to the primary server again. The following
commands can be used to set the primary server to be
that NAS can communicate with it immediately after a fault has been resolved.
When the primary and secondary servers are both
the packets to the primary server only.
Perform the following configurations in RADIUS Scheme View.
Table 323 Setting the RADIUS Server State
Operation
Set the state of primary RADIUS server
Set the state of second RADIUS server
By default, for the newly created RADIUS scheme, the primary and secondary
accounting/authentication servers are in the state of
RADIUS scheme created by the system, the primary accounting/authentication
servers are in the state of
servers are in the state of
Command
state primary { accounting |
authentication } { block | active }
state secondary{ accounting |
authentication } { block | active }
, and the secondary accounting/authentication
active
.
block
Command
retry retry_times
undo retry
Command
server-type { 3com |
standard }
undo server_type
manually, in order
active
or , NAS will send
active block
; for the "system"
block
,
standard