3Com SuperStack 4 Configuration Manual page 216

228 C 8: ACL C
HAPTER ONFIGURATION
Importing ACL
Configuration Example
Table 255 Defining Basic ACL
Operation
Enter basic ACL (System View)
Define a sub-rule (Basic ACL
View)
Delete a sub-rule (Basic ACL
View)
Delete an ACL or all ACLs
(System View)
You can define multiple rules for an ACL by using the
times.
You can import a defined ACL in User Interface View to achieve ACL control.
Perform the following configurations respectively in System View and User
Interface View.
Table 256 Importing ACL
Operation
Enter user interface view
(System View)
Import the ACL (User Interface
View)
See the Command Reference Manual for details about these commands.
Networking Requirement
Only the Telnet users from 10.110.100.52 and 10.110.100.46 can access the
Switch.
Networking Diagram
Figure 56 ACL configuration for Telnet users
Internet
Switch
Configuration Procedure
1 Define a basic ACL.
[SW5500]acl number 2000 match-order config
[SW5500-acl-basic-2000]rule 1 permit source 10.110.100.52 0
[SW5500-acl-basic-2000]rule 2 permit source 10.110.100.46 0
[SW5500-acl-basic-2000]quit
Command
acl number acl_number
auto }
rule-id
rule [ ] { permit | deny } [ source
source_addr wildcard
{
| logging | time-range
undo rule rule_id [ source | fragment |
logging | time-range ]*
acl_number
undo acl { number
Command
type
user-interface [
]
last_number
acl_number
acl { inbound | outbound }
match-order { config |
| any } | fragment
name
]*
| all }
command several
rule
first_number
] [