3Com SuperStack 4 Configuration Manual page 308

320 C 12: F S
HAPTER ILE YSTEM
Enable HWPing Client
Creating a Test Group
Configure the Test
Parameter
M
ANAGEMENT
Configure the Test Parameter
■
By enabling HWPing client, various types of tests can be set and carried out.
Perform the following configurations in System View.
Table 370 Enable HWPing Client
Operation
Enable HWPing client
Disable HWPing client
By default, HWPing Client is disabled.
HWPing test group is a set of HWPing test items. Each test group includes several
test items and is uniquely identified by an administrator name plus an operation
tag.
You may perform HWPing test after creating a test group and configuring all the
parameters.
Perform the following configurations in System View.
Table 371 Create a Test Group
Operation
Create a test group
Remove the test group
By default, no test group is configured.
The following parameters are included in an HWPing test group:
Destination address
■
Test type
■
Number of packets sent for a test
■
Packet transmission interval
■
Test timeout time
■
Configuring a Destination Address
The Destination address is equal to the destination address in a
Perform the following configurations in HWPing Test Group View.
Table 372 Configuring a Destination Address
Operation
Configure a destination address
Delete the destination address
By default, no destination address is configured.
Command
hwping-agent enable
undo hwping-agent enabled
Command
administrator-name operation-tag
hwping
undo hwping administrator-name operation-tag
Command
destination-ip
undo destination-ip
command.
ping
ip-address