3Com SuperStack 4 Configuration Manual page 287

Configuring the Name of
the Configuration File
used for the Next
Startup.
FTP Overview
You may erase the configuration files from the Flash in the following cases:
After being upgraded, the software does not match with the configuration
■
files.
The configuration files in flash are damaged. (A common case is that a wrong
■
configuration file has been downloaded.)
Perform the following configuration in User View.
Table 341 Configure the Name of the Configuration File used for the Next Startup
Operation
Configure the name of the configuration
file used for the next startup
is the name of the configuration file and its extension name can be
cfgfile
".cfg". The file is stored in the root directory of the storage devices.
After the above configuration, execute
the running of the configuration files, and to verify the effect of the configuration.
Table 342 Display the Information of the File used at Startup
Operation
Display the information of the file used at startup
FTP is a common way to transmit files on the Internet and IP network. Before the
World Wide Web (WWW), files were transmitted in the command line mode and
FTP was the most popular application. Even now, FTP is still used widely, while
most users transmit files via email and Web.
FTP, a TCP/IP protocol on the application layer, is used for transmitting files
between a remote server and a local host.
The Switch provides the following FTP services:
FTP server: You can run FTP client program to log in the server and access the
■
files on it.
FTP client: After connected to the server through running the terminal emulator
■
or Telnet on a PC, you can access the files on it, using FTP command.
Figure 71 FTP Configuration
Switch Switch Switch
Command
startup saved-configuration [
cfgfile
unit unitid ]
command in any view to display
display
Command
display startup
Network Network
PC PC
FTP Overview 299