3Com SuperStack 4 Configuration Manual page 319

Table 389 Configuring to Output Information to Loghost
Operation
Output information to loghost
Cancel the configuration of
outputting information to loghost
Ensure to enter the correct IP address using the
to configure loghost IP address. If you enter a loopback address, the system
prompts of invalid address appears.
3 Configuring the information source on the Switch
With this command, you can define the information that is sent to the control
terminal, such as: generated by which modules, information type, information
level, and so on.
Perform the following operation in System View.
Figure 84 Defining Information Source
Operation
Define information source
Cancel the configuration of
information source
specifies the module name;
modu-name
refers to the severity levels;
The information with the level below it will not be output.
specifies the channel number and
When defining the information sent to the loghost,
must be set to the channel that corresponds to loghost direction.
channel-name
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
debugging
source, meantime using the
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Table 390 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Command
info-center loghost
channel { c
hannel-number
local-number
| facility
chinese | english } ]
undo info-center loghost
info-center loghost
Command
info-center source {
channel-number
channel {
log | trap | debug }* { level
state state }* ]
undo info-center source {
channel-number
} channel {
represents all the modules;
default
specifies the severity level of information.
severity
channel-name
as the information type when configuring information
command to turn on the debugging
debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
Logging Function
host-ip-addr
channel-name
|
| language {
host-ip-addr
command
modu-name
| default }
channel-name
|
severity
modu-name
| default
channel-name
|
channel-number
specifies the channel name.
or
channel-number
331
[
}
} [ {
|
}
level
default