3Com SuperStack 4 Configuration Manual page 325

Sending the Information
to the Trap Buffer
Table 404 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
To send information to the trap buffer, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 405 Enabling/Disabling Info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to the trap buffer.
Perform the following operation in System View.
Table 406 Configuring the Output Information to Trap Buffer
Operation
Output information to trap buffer
Cancel the configuration of
outputting information to trap buffer
3 Configuring the information source on the Switch.
With this configuration, you can define the information that is sent to the trap
buffer: generated by which modules, information type, information level, and so
on.
Perform the following operation in System View.
Table 407 Defining Information Source
Operation
Define information source
Cancel the configuration of
information source
specifies the module name;
modu-name
refers to the severity levels;
The information with the level below it will not be output.
specifies the channel number and
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log |
trap | debugging }
Command
info-center enable
undo info-center enable
Command
info-center trapbuffer [ size
buffersize
channel-name
|
undo info-center trapbuffer [ channel
| size ]
Command
info-center source {
channel-number
channel {
log | trap | debug }* { level
state }* ]
undo info-center source {
channel-number
} channel {
default
specifies the severity level of information.
severity
channel-name
Logging Function
channel-number
| channel {
} ]
modu-name
| default }
channel-name
|
severity
modu-name | default
channel-name
|
represents all the modules;
channel-number
specifies the channel name.
337
} [ {
| state
}
level