3Com SuperStack 4 Configuration Manual page 26

38 C 1: G
HAPTER ETTING
User Interface
Configuration
S
TARTED
Tasks for configuring the user interface are described in the following sections:
Entering User Interface View
■
Configuring the User Interface-Supported Protocol
■
Configuring the Attributes of AUX (Console) Port
■
Configuring the Terminal Attributes
■
Managing Users
■
Configuring Redirection
■
Entering User Interface View
Use the
user-interface
a single User Interface View or multi User Interface View to configure one or more
user interfaces respectively.
Perform the following configuration in System View.
Table 10 Entering User Interface View
Operation
Enter a single User Interface View or multi User
Interface Views
Configuring the User Interface-Supported Protocol
The following command is used for setting the supported protocol by the current
user interface. You can log in to the Switch only through the supported protocol.
The configuration becomes effective when you log in again.
Perform the following configurations in User Interface (VTY user interface only)
View.
Table 11 Configuring the User Interface-supported Protocol
Operation
Configure the user interface-supported
protocol
By default, the user interface supports Telnet and SSH protocols.
If the Telnet protocol is specified, to ensure a successful login through Telnet, you
must configure the password by default.
If SSH protocol is specified, to ensure a successful login, you must configure the
local or remote authentication of username and password using the
authentication-mode scheme
configuration fails if you configure
authentication-mode none
the user interface, then you cannot configure
and
authentication-mode none
Configuring the Attributes of AUX (Console) Port
Use the ,
speed flow control
configure these attributes of the AUX (console) port.
command to enter a User Interface View. You can enter
Command
user-interface [ type ]
first-number [ last-number
]
Command
protocol inbound { all | ssh |
telnet }
command. The
protocol inbound ssh
authentication-mode password
. When you configure SSH protocol successfully for
authentication-mode password
any more.
, ,
parity stop bit
and
, and commands to
data bit