3Com SuperStack 4 Configuration Manual page 321

Sending the Information
to Telnet Terminal or
Dumb Termina
When defining the information sent to the control terminal,
must be set to the channel that corresponds to the Console
channel-name
direction.
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
debugging
source, meantime using the
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Table 394 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
4 Enable terminal display function
To view the output information at the control terminal, you must first enable the
corresponding log, debugging and trap information functions at the Switch.
For example, if you have set the log information as the information sent to the
control terminal, now you need to use the
enable the terminal display function of log information on the Switch, then you
can view the information at the control terminal.
Perform the following operation in User View:
Table 395 Enabling Terminal Display Function
Operation
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information
To send information to a Telnet terminal or dumb terminal, follow the steps below:
l
1 Enabling info-center
Perform the following operation in System View.
as the information type when configuring information
command to turn on the debugging
debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap
| debugging }
terminal logging
Command
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
Logging Function 333
or
channel-number
default
command to